TLC-4S Tally Controller Front and Back

The TLC-4S controller connects to any HD TriCaster including the TC40, TC-Mini, TC1 and VMC1. The software supports both the red program and green preview tally lights. You can also globally enable or disable the talent tally via the software with no jumpers to change.

Another new feature lets you assign any of the six tally outputs to any of the switcher inputs so assign a tally to a network input or a DDR*.

One of the things that sets the TLC-4S apart from a simple adapter cable is the intercom pass through so you can run both tally and intercom on a single Cat5 cable run. Connect your intercom base station into the xlr on the TLC-4S then connect your beltpacks to the multi-purpose port on the tally lights.

*TC1 currently only supports tally on the first four inputs
Features:
  • Six assignable tally outputs.
  • Program tally and Preview tally
  • ‘Talent’ tally (global software enable/disable)
  • Intercom/audio pass through
  • Compatible with all metaSETZ tally lights and relay units

System requirements:

TriCaster TC1 all versions
IP Series VMC1 all versions
TriCaster Mini, 410, 460 or 860 all versions
TriCaster 40, 455, 855 rev 6 software
TriCaster 8000 rev 2-2-131031 Software
TriCaster 450, 850 or Extreme do not support the TLC-4S.

Available USB port or powered USB hub

Please note TC software rev requirements.

Call 1-800-692-6442 to order

 

Related Products:

Share →

One Response to metaSETZ TLC-4S Tally Controller for TriCaster

  1. Ron Bax says:

    Dear Tech Support.

    I’m trying to ascertain the nature of the TLC-4S outputs. Are they switch closures, Voltages, currents, a TTL or CMOS logic level, or some sort of encoded signal? If a Voltage, what is the max available source/sink current per selected output? I’m trying to interface to a DIY Relay Driver for our existing tally lights. The Driver requires an Active HIGH, +3 to +5 VDC, sourced at ~25 mA to ENABLE a tally light relay. It can also be reversed, where a LOW (~0V, sinking 25 mA) ENABLES a tally light relay. I can also reconfigure the Driver for 5V, Standard or Low Power TTL or CMOS Input levels of either polarity, as long as I know the TLC-4S output characteristics.

    Thanks,

    Ron